Lifan 100-C 2012, Руководство пользователя

Страница: 13 / 22

Fig. 18
Dipstick Upper mark
Lower mark
ENGINE OIL (EP)
Check of Engine Oil (Fig. 18)
Check the engine oil level every use.
The dipstick
is located onto the rear
portion of the right crankcase cover. The
level must be maintained between upper
mark
and lower mark .
Place the motorcycle on a level ground
with the center stand. Remove the
dipstick, wipe it clean. Reinsert and
screw in the dipstick, then remove it for
checking.
Add engine oil SAE15W/40-SE to up-
per level mark. Do not overfill.
Insert the dipstick. Check for leaks.
CAUTION Running the engine with
insufficient oil can cause serious dam-
age to the engine.
Fig. 19 Drain plug
Change of Engine Oil (Fig. 19)
It is better to drain when the engine is still warmed.
Place an empty container under the engine, unscrew the drain plug.
Shift the transmission into neutral, operate the starter button several times
so as to help empty the oil thoroughly.
Reinstall the drain plug, and tighten it up.
Pour approx. 1L of SAE15W/40-SE into the engine. Restart the engine,
keep it idle for a few minutes, and then stall it. Recheck the oil level, and add
oil if necessary.
CAUTION When running in very dusty conditions, oil changes
should be performed more frequently than specifed in the mainte-
nance schedule.
CLEAR AWAY CARBON DEPOSIT (EP)
Clear away carbon deposit around the spark plug and piston ring, on the
Soak the element in gasoline engine
oil SAE15W/40-SE until saturated, and
then squeeze out the excess oil.
Reassemble the air cleaner in the re-
verse order of removal.
CAUTION The spark plug must be securely tightened. Improperly
tightened plug can become very hot and possibly damage the engine.
AIR CLEANER (EP)
(Fig. 21)
The air cleaner must be cleaned and then soaked in clean oil at least once
every 4000km’s drive. Riding in very dusty area, the job should be done more
often. See your dealer for further information.
Remove the right side cover. Loosen off the screws, remove the air cleaner
cover and take the filter element out of the air cleaner housing.
Wash the element in cleansing solvent and dry it.
piston top, in the piston ring slot and combustion
chamber regularly.
SPARK PLUG (EP)
(Fig. 20)
Spark Plug Type C7HSA
Check and Replace
Disconnect the spark plug cap from the spark plug.
Clean any dirt from around the spark plug base.
Remove the spark plug by the special wrench.
Inspect the electrodes and center porcelain for
deposits, and clean with a wire brush. If the spark
plug is damaged, replace it.
Check the spark plug gap which should be 0.7 0.
1mm, and adjust by bending the side electrode if
necessary.
Side electrode
Fig. 20
１００－Ｃ（ＥＮＧＬＩＳＨ）ＯＫ．ｐ６５
2012-9-12, 16:27 13