17
Instructions to the OEM/Integrator:
This module has been granted modular approval for mobile applications. OEM
integrators for host products may use the module in their final products without additional
FCC certification if they meet the following conditions. Otherwise, Additional FCC
approvals must be obtained.
The OEM must comply with the FCC labeling requirements. If the module’s label is
not visible when installed, then an additional permanent label must be applied on the
outside of the finished product which states: ”Contains transmitter module FCC ID:
2AOFDLSD4BT-E9X,Additionally, the following statement should be included on the
label and in the final product’s user manual:
“This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interferences, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.”
The user’s manual for the host product must clearly indicate the operating
requirements and conditions that must be observed to ensure compliance with current
FCC RF exposure guidelines.
The final host / module combination may also need to be evaluated against the FCC
Part 15B criteria for unintentional radiators in order to be properly authorized for
operation as a Part 15 digital device.
This Module is full modular approval, it is limited to OEM installation ONLY.
The module is limited to installation in mobile application.
A separate approval is required for all other operating configurations, including
portable configurations with respect to Part 2.1093 and difference antenna
configurations.
The OEM integrator is responsible for ensuring that the end-user has no manual
instruction to remove or install module.
The Grantee will provide guidance to the Host Manufacturer for compliance with the
Part 15B requirements if requested.
