Liebert OpenComms, Инструкция по установке и эксплуатации

Страница: 23 / 42

22 System Configuration
5. Firmware Update Menu
The Firmware Update Menu is intended for Liebert service
personnel only. No user configurable parameters are accessed in
this selection. If entered, to escape, power must be cycled on the
card.
6. Factory Settings Menu
The Factory Settings Menu displays the manufacture date, serial
number and MAC address of the card. These parameters are
read-only. Once all parameters have been entered, press
<escape> to return to the Main menu; then press <x> to save
configuration, exit and reboot to enable the new configuration.
All parameters are stored in non-volatile flash memory.
Alternately, pressing <q> after <escape> will abort all changes.
Neither selection is case-sensitive.
7. Auxiliary Communications
The Auxiliary Communications Menu allows the user to set up
the parameters necessary for Modbus communications. The user
can enable / disable the Modbus sessions as well as assign the
slave ID.
Once all parameters have been entered, press <escape> to return
to the Main menu; then
press <x> to save configuration , exit
and reboot using the new configuration. All parameters are
stored in non-volatile flash memory. Alternately,
<q> will abort
all changes . Both selections are not case-sensitive.