Liebert PSA itON Installation and User Manual
Installation
4. Installation
Installing the UPS is as easy as following the steps shown. Be aware that the power Switch must
be kept in the “ON” position, otherwise, the UPS will be disabled and your equipment will not be
protected during a power failure.
4.1 Inspection
Remove the UPS from its package and inspect it for damage that may have occurred during
shipping. If any damage is discovered, re-pack the unit and return it to the place of purchase.
4.2 Placement
Install the UPS unit in any protected environment that provides adequate airflow around the unit,
and is free from excessive dust, corrosive fumes and conductive contaminants. Do not operate your
UPS in an environment where the ambient temperature or humidity is high.
Also, place the UPS unit away from the monitor at least 20cm to avoid interference.
4.3 Charging
This unit is shipped from the factory with its internal battery fully charged, however, some charge
may be lost during shipping and the battery should be recharged prior to use. Plug the unit into an
appropriate power supply and allow the UPS to charge fully by leaving it plugged in for at least 8
hours.
itON 600
itON 600
(India Version)
itON 1000
Page
７
V2.8
Emerson Network Power
