LIBERTY AV SOLUTIONS Intelix AS-1H1V, Инструкция по установке и эксплуатации

Страница: 12 / 24

AS-1H1V Installation Guide
12
General Operation
Automatic Switching
Contact Closure Switching
RS232 Switching
LED Indicators
Inputs
Status
By placing a jumper between the “Auto” and “Gnd” terminals on the back of the AS-1H1V, the unit will switch
inputs by sensing an active video signal.
The AS-1H1V will switch automatically to the “last in” connected input. For example, if an VGA signal is currently
displayed, and then connect an HDMI source, the unit will switch to the HDMI input. When the HDMI source is
removed, the unit will switch back to the VGA input.
By connecting the RS232 port of the HDBaseT receiver to a third party control system, serial commands can perform
switching functions, as well as provide greater information about the units status. RS232 control can be used
simultaneously with Auto and Contact Closure operation, but not when using the Display Control functionality.
By connecting momentary switches to the contact closure inputs (see p.9) you can create push-button control of
the input selection on the AS-1H1V.
When using “Auto-switching with manual override”, the unit will function as described in the “Auto” section above,
but pressing one of the override buttons will cause the unit to switch to the selected input. If there is no video
signal connected to the selected input, you will experience a black video screen.
When using “Manual switching mode”, the unit will only switch when the button that corresponds to the input
selection is pressed. If no video is present on the selected input, you will experience a black video screen.
LED State Description
Off(both) Unit is in low power mode
Off (one) Unit is on – no signal detected on input, input not selected
Green Input selected
Amber Input has active video, input not selected
LED State Description
Link On Connected to active HDBaseT receiver
Link Off Not connected to active HDBaseT receiver or in low power mode
HDCP Solid Encrypted HDCP signal to display
HDCP Flashing Non-encrypted HDCP signal to display
HDCP Off No HDCP link between source and display or in low power mode
The AS-1H1V has two bi-color LEDs to provide switching status.
The AS-1H1V has two LEDs to provide connectivity status.