-5-
v7.0
General
2. General
2.1. General and safety information
•
In this section, the term “Waspmote” encompasses both the Waspmote device itself and it enclosure.
•
Read through the document “General Conditions of Libelium Sale and Use”.
•
Do not allow contact of metallic objects with the electronic part to avoid injuries and burns.
•
NEVER submerge the device in any liquid with the enclosure open.
•
Keep the device in a dry place and away from any liquid which may spill.
•
Waspmote consists of highly sensitive electronics which is accessible to the exterior, handle with great care and avoid
bangs or hard brushing against surfaces.
•
Check the product specifications section for the maximum allowed power voltage and amperage range and consequently
always use a current transformer and a battery which works within that range. Libelium is only responsible for the correct
operation of the device with the batteries, power supplies and chargers which it supplies.
•
Keep the device within the specified range of temperatures in the specifications section.
•
Do not connect or power the device with damaged cables or batteries.
•
Place the device in a place only accessible to maintenance personnel (a restricted area).
•
Keep children away from the device in all circumstances.
•
If there is an electrical failure, disconnect the main switch immediately and disconnect that battery or any other power
supply that is being used.
•
If a hardware failure occurs, consult the Libelium Web Development section.
•
Check that the frequency and power of the communication radio modules together with the integrated antennas are
allowed in the area where you want to use the device.
2.2. Conditions of use
•
Read the “General and Safety Information” section carefully and keep the manual for future consultation.
•
Use Waspmote in accordance with the electrical specifications and the environment described in the “Hardware” section of
this manual.
•
Do not place Waspmote in contact with metallic surfaces; they could cause short-circuits which will permanently damage it.
•
IMPORTANT It is the responsibility of the installer to find out about restrictions of use for frequency bands in each country
and act in accordance with the given regulations. Libelium Comunicaciones Distribuidas S.L does not list the entire set of
standards that must be met for each country.
•
For further information go to:
-
CEPT ERC 70-03E - Technical Requirements, European restrictions and general requirements:
http://www.erodocdb.dk/
-
R&TTE Directive - Equipment requirements, placement on market:
http://www.erodocdb.dk/
•
Further information you may need can be found at:
http://www.libelium.com/development/waspmote
•
The “General Conditions of Libelium Sale and Use” document can be found at:
http://www.libelium.com/development/waspmote/technical_service
