INSTALLATION
Note: The model in the photo may differ from yours. Both models are installed in the same way.
Before installing, secure the hanging bracket (11) to the heater. Using the Allen key, undo the Allen screw
(12) and pull the pin with the other screw out of the hole. Place the hanging bracket (11) between both
holes as indicated on the diagram. Push the pin with the second screw back through the holes and the
hanging bracket. Then place the first Allen screw back and turn to secure using the Allen key.
The Liangdi HEAT AND BEAT heater can be installed in three ways:
Suspension from a wall (or possibly ceiling) by means of a wall bracket
Suspension from a frame (parasol, tent or similar item) by means of a bracket
Suspension from a ceiling by means of chains
Remove all packaging material (including the shock absorbing material around the bulb) before
installation the heater and check the heater, supply cord and the plug for signs of damage. Carefully
choose the correct location to install your heater. Before fastening, check that the minimum safe
distances between the surroundings and the chosen location are followed:
Minimum distance lowest point of heater to floor: 1.8 m
Minimum distance heater to heated object: 1 m
Minimum distance top* heater to fire-resistant ceiling: 0.25 m
Minimum distance top* heater to tent tarpaulin, parasol etc.: 0.5 m
Minimum distance side heater to walls, obstacles, objects: 0.5 m
* The top of the heater is the side where the suspension bracket is attached. If you suspend the device
outside, ensure that it is protected from the wind.
The following applies for all options:
Always lead the electrical cable directly away from the heater. It
may not become hot.
You can adjust the heating angle by loosening both Allen screws
slightly. The heater can rotate through approximately 60°; the
recommended beam angle is 45° (see image). When adjusting
the angle ensure that the heater does not radiate heat onto
flammable materials close by.
Confirm that the heater is firmly mounted and all screws
fastenend.
For personal safety, alway connect the heater to an earthed
socket. Now your infrared heater is ready for use.
Suspension from a wall (or ceiling) by means of the wall bracket
The heater must be mounted on a fire-resistant foundation that
is vibration free and stable enough. Check or the provided
dowels and screws are suitable, strong enough and qualified for
the foundation. When mounting on wood, please ensure safe
distances as specified above.
Fix the mounting bracket horizontally on the wall with the four
anchor dowels provided (see picture on the right).
Hang the terrace heater with the suspension bracket in the wall
bracket. Refer to the picture. Slide the bracket through the wall
bracket as far as possible – the small hole in the bracket
protrudes under the wall bracket. Secure the heater by screwing
the short wing nut (supplied) as far as possible into the small
hole in the suspension bracket.
