LI-COR LI-7815, Инструкция по эксплуатации

Страница: 19 / 98

Charging batteries with an external charger
The optional single-bay charger (part number 590-11830; Inspired Energy CH7000A)
can charge one battery at a time. To use the charger, plug it into a wall socket and
place a battery in the dock. The charger is compatible with 100 to 240 VAC power at
50 to 60 Hz. A blinking LED indicates charging; a solid green LED indicates a full
charge.
Note: An optional automobile adapter kit is available to charge the battery from
an automobile. Leave the automobile running when charging the battery to pre-
vent excessive discharge of the automobile battery.
Warning: Charge batteries only with a SMBUS compliant level 2 or 3 charger. Do not
heat above 80 °C. Do not open battery, dispose of in fire, or short circuit—may ignite,
explode, leak, or get hot, causing personal injury. Replace battery with same part num-
ber only. Use of another battery may present a risk of fire or explosion. Keep away from
children.
Avertissement: Ne rechargez les batteries qu’avec un chargeur conforme au SMBUS
niveau 2 ou 3. Ne chauffez pas au-dessus de 80 °C. Ne pas ouvrir la batterie, ni ne la
jeter au feu ou court-circuiter—elle peut mettre à feu, exploser, couler, ou s’échauffer,
causant des blessures personnelles. Remplacez les batteries seulement avec le même
numéro de pièce. L’utilisation d’une autre batterie peut presenter un risque, ou un incen-
die ou une explosion. A garder hors de portee des enfants.
External power source
Figure 2-1. The auxiliary power cable
has bare leads that connect to a power
supply.
You can power the instrument with any
10.5 to 33 VDC power source, such as a
deep-cycle marine battery with >20 amp-
hour capacity. The external power source
should be connected with the auxiliary
power cable (optional; part number 9968-
242). Attach both red leads to positive (+)
and both black leads to negative (-).
Section 2. Getting started
2-3 External power source