LGMG SR1623, Руководство по эксплуатации и обслуживанию

Страница: 77 / 86

Lifting Work Platform Operation and Maintenance Manual
70
14) Install the hydraulic oil tank on the equipment.
15) Install hose.
16) Fill the hydraulic oil to the hydraulic oil tank until the liquid level is between 1/3 - 2/3 of the sight
gauge, and it is forbidden to overflow.
17) Scrub off the hydraulic oil that may be sprayed out.
18) Open the ball valve on the hydraulic oil tank.
△
! Danger of damage to components, after installing the hydraulic oil tank, make sure to open
two ball valves of the hydraulic oil tank and fill the pump with oil.
19) Check the functions of all machines through an entire cycle and check for oil leakage.
20) Recheck the liquid level of oil tank and refill oil to 1/3 - 2/3 after an operating cycle.
11.16 Check for the Oil Level in the Reducer
Check this step every 250 hours or a quarter.
The incorrect oil level in the reducer shall lead to the reduction of equipment performance and
continuous use will result in damage to components.
1) Drive the equipment rotating until a plug is at the highest point, and the other is 90 degrees from this
one.
2) Remove the plug at 90 degrees and check the oil level.
Result: The oil level shall be the same as the bottom of the side plug hole.
3) When required, remove the upper plug and refill oil until the oil level is the same as the bottom of the
side plug hole.
4) Apply the pipe thread sealant to the plug and install the plug in the reducer.
5) Repeat this step for each reducer.
Oil specification 80-90/W
Capacity 0.68 L (each reducer)
11.17 Replacement of the Gear Oil of Reducer
It is available in the first 50 hours, and it will be replaced every 1,000 hours or a year.
It is necessary to replace the gear oil of reducer to maintain good equipment performance and service
life. Failure to replace the reducer engine oil every year may result in reduced equipment performance,
and continuous use may result in damage to components.
1) Select the reducer to be maintained, and drive the equipment until one plug is at the lowest point.
2) Remove the two plugs and drain the oil (note to be drained) into the proper container.
3) Drive the equipment rotating until a plug is at the highest point, and the other is 90 degrees from this
one.
4) Refill oil from the hole of reducer at the high point until the liquid level is the same as the side hole at
the bottom. Install a plug.
5) Repeat this procedure for each reducer to refuel.
Oil specification 80-90/W
Capacity 0.68 L (each reducer)