LGMG AS0607E, Руководство по обслуживанию

Страница: 23 / 48

Maintenance Manual of Elevating Work Platform
18
raise the platform by about 0.3m
Result: the diagnosis screen displays the
code 18, the alarm is sounds and the lifting
function is enabled. The function of machine
is normal.
Result: The diagnosis screen is not display
the code 18 and the alarm is sounds. In such
case, the limit switch shall be replaced.
17) Raise the platform until the hollow protector
is stretched.
Result: The diagnosis screen is not display
the code 18 and the alarm is sounds. The
function of machine is normal.
Result: The diagnosis screen displays the
code 18 and the alarm is sounds. In such case,
the limit switch shall be replaced.
18) Lift the platform for a given height above the
ground. The lifting height of every model is
given in the following table.
Model Height (m)
SS0407E 1.8
AS0607E 2.5
AS0812E 3.2
AS1012E 3.73
AS1212E
4
AS1413E
19) Lift the safety prop, move it to the center of
the scissor sleeve center and rotate it upward
until it is vertical.
20) Lower the platform height until the safety
prop completely contacts the shaft sleeve.
21) Warning: crush hazard
22) Turn the key switch to the OFF position.
23) Remove the platform control line connected
to the main chassis harness.
24) Resume the connection between the
platform controller connector and the main
chassis harness.
25) Connect the platform control connector.
26) Safely and correctly connect the connector of
lower limit switch.
27) Well install the lower limit switch box.
28) Switch the key switch to the platform
controller.
29) Slightly raise the platform and recover the
safety prop to the installation position.
30) Lower the platform to the folding position
。
Inclination switch
31) Move the machine to the maximum allowable
inclination angle of the level sensor. For the
maximum allowable inclination angle, please
refer to the nameplate.
32) Press the lifting button to lift the machine for
a given height on a slope.
Result: The diagnosis screen displays the
code LL, the alarm sounds and the machine
function is normal.
Result: The diagnosis screen does not
display the code LL, the alarm sounds. In such
case, please check or replace inclination