LGMG AS0607E, Руководство по обслуживанию

Страница: 16 / 48

Maintenance Manual of Elevating Work Platform
11
Wire in battery area of the battery tray
Internal of platform controller box
3) Switch the key switch to the platform
controller and draw out the red emergency
stop buttons from the ground and platform
controller.
4) Lift the platform for a given height above the
ground. The lifting height of every model is
given in the following table.
Model Height (m)
SS0407E 1.8
AS0607E 2.5
AS0812E 3.2
AS1012E 3.73
AS1212E
4
AS1413E
5) Lift the safety prop, move it to the center of
the scissor sleeve center and rotate it upward
until it is vertical
6) Lower the platform height until the safety
prop completely contacts the shaft sleeve
△
! Hazard
：
Crush hazard
Be sure to put your hand on correct
position of the safety prop when
lowering the platform
7) Check if there is any burn, scratched, eroded,
bent and loosened wire in chassis and the
scissor area..
8) Check if there is any burn, scratched, eroded,
bent and loosened wire in the areas below:
Wire of scissor arm
ECU to the platform
Harness connector connected on the
platform
9) Check the free coating of the insulating oil on
the positions below:
Harness connector connected between ECU
and platform controller
All harness connectors connected the level
sensor
10) Raise the platform and recover the safety
prop to the installation position.
11) Lower the platform to the folding position and
then shut down the machine
B-3
Inspection of tyre and rim
This check shall be made once per 25h or per
month, whichever is shorter.
Keeping the tyre and rim in good conditions is
essential to safe operation and good performance.
The failure of tyre and rim is possible to tip over
the machine. The machine elements can also be
damaged, if the defected tyres and rims are not
discovered and repaired.
1) Check if the tread and sides of the tyre
contain any scratch, crack, hole and other
abnormal wear.
2) Check if the rim is damaged, bent and
cracked
3) Remove the cotter pin and check the nut
torque