LGMG AR16J, Руководство по обслуживанию

Страница: 14 / 32

Maintenance Manual of Elevating Work Platform
9
△
!
Perform the step when the engine
flames out.
Figure 1-6
1. Fuel supply flow to the pump
2. Venting screw
3 .Electrical connection for water level sensor
4. Drain plug
5. Filter insert
6. Fuel inlet from the fuel tank
Check and drain the fuel filter every 8 hours or
every day.
1) Shut down the engine, and find the fuel
filter.
2) Disconnect cable connection.
3)
Loosen the drainage plug located at the
bottom of the filter cartridge, allowing the
water drained to an appropriate container.
Once any fuel starts to flow out, screw
down the drainage plug immediately.
4)
Wipe up any fuel that may be splashed.
5) Start the engine from the ground control
and inspect whether or not there is leakage
in the fuel filter.
Change the fuel pre-filter insert
1) Switch off the engine.
2) Shut off the fuel supply to the engine (with
high-level tank).
3) Place suitable collecting containers
underneath.
4) Disconnect cable connections.
5) Loosen drain plug and drain liquid.
6) Disassemble filter insert.
7) Clean any dirt of the opposite side of filter
head.
8) Wet the sealing surfaces of the filter
cartridge slightly with fuel and screw back
on to the filter head, clockwise (17-18 Nm).
9) Mount drain plug.
10) Open the fuel shutoff tap and vent the
system, see venting the fuel system.
Vent the fuel system
The fuel system is vented via the electric fuel
supply pump.
In order to ensure that no error messages are
generated, no attempt should be made to start
the system up whilst venting.
This process is carried out as follows:
● Ignition "ON"
The electronic fuel supply pump switches on for
20 seconds in order to vent the fuel system and
build up the required fuel pressure.
Wait until the electric fuel supply pump is
disconnected from the control unit.
● Ignition "OFF"
Repeat the process at least 2 times until the fuel
system is vented
△
! Risk of explosion and fire. Where there
is fuel leakage, prevent any irrelevant
personnel from entering the area and strictly
prohibit operating the equipment. Repair the
leak immediately.