LG WD205C Series, Руководство по обслуживанию

Страница: 20 / 26

20
7. ERROR CODES
Problem Possible Cause Solutions
The display shows: Drawer is not closed properly Close the drawer and press START/PAUSE
button to start the cycle.
If the drawer is closed and the drawer lock er-
ror message is displayed, call for service
The display shows:
Lid is not closed properly Open the drawer and make sure the latch area
is free of clothing or other obstructions.
Close the lid, shut the drawer, and press
START/PAUSE to start the cycle.
If the lid is closed and the lid error picto is
blinked, call for service
Washer fills with water slowly or
not at all, or the display shows: Water supply faucets are not fully
open. Make sure that the water faucets are fully
open.
Water line hoses are kinked,
pinched, or crushed. Make sure that the hoses are not kinked or
pinched. Be careful when moving the washer
during cleaning and maintenance.
Water inlet filters are clogged. Clean the inlet filters. See Maintenance in the
Care and Cleaning section.
Water supply pressure to faucet or
house is too low. Check another faucet in the house to make
sure that household water pressure is ad-
equate and flow is not restricted. Disconnect
the inlet hose from the washer and run a few
gallons of water through the hose to flush the
water supply lines. If flow is too low, contact a
plumber to have the water lines repaired.
Water supply connected with leak-
limiting hoses. Hoses designed to limit leaks can trip falsely
and prevent the washer from filling. The use
of leak limiting hoses is not recommended.
Washer will not turn on Power cord is not properly plugged
in.
House fuse is blown, circuit break-
er has tripped, or power outage
has occurred. Make sure that the plug is plugged seruely
into a grounderd, 3-prong. 120-VAC, 60-Hz.
outlet.
Reset circuit breaker or replace fuse. Do not
increase fuse capacity. If the problem is a
circuit overload, have it corrected by a quali-
fied electrician.
Water in the washer drains slowly
or not at all, or the display shows: Drain hose is kinked, pinched, or
clogged
Drain discharge is more than
96 " (243.84 cm) above bottom of
washer.
Make sure the drain hose is free of clogs,
kinks, etc., and is not pinched behind or under
the washer.
Adjust or repair drain. Maximum drain height
is 96 " (243.84 cm).
Washer chimes repeatedly before
final rinse This is not an error. This is an alert
to allow the addition of liquid fabric
softener before the final rinse.. See Using Fabric Softener, page 16, for in-
structions on adding liquid fabric softener to
the load.
To disable or enable the fabric softener alert,
press and hold Warm Water and Extra Rinse
at the same time for three seconds.
LGE Internal Use Only
Copyright © 201 6 ~ 201 7 LG Electronics Inc. All rights
reserved. Only training and service purposes.