ENGLISH
31
Device ID
•
Sets the ID of a device(Logical Address) connected to the CEC Line. You can choose ‘All’ and from ‘0 x 01’ to ‘0 x 0E’(All, 0 x 01 ~ 0 x 0e).
•
The default value is ‘All’.
StandBy
•
Set the sending and receiving scenario of OpStandBy(0 x 0c) command.
•
Ths detailed scenario is described on the table below.
Send
Receive
Send Only
O
X
Receive Only
X
O
All
O
O
Off
X
X
Forced Initialize
•
This setting will be enabled When CEC mode is set as ‘TVLink-CEC’.
•
If ‘Enable” is selected, TV will change its input source to HDMI1 by any HDMI-CEC simulation from a device.
HTNG Hotel Mode
•
If you use following functions via TVLink-HCEC, HTNG Hotel mode will be set as “Yes” automatically.
-
Power On Default, Start Volume, Maximum Volume, Minimum Volume, or Start Volume.
•
Even if ‘Hotel Mode Operation’ is set as No, above settings are still effective.
Clock Setup
Clock Display
(Depending on model)
•
You can select ‘Enable’ or ‘Disable’.
•
After selecting ‘Enable’, you can see the LED Clock TV.
Dimming Standby
(Depending on model)
•
Standby Dimming value Range : 1~2
Dimming PowerOn
(Depending on model)
•
PowerOn Dimming value Range: 1~5
Clock Source
•
You can select ‘Off’, ‘Pro:Centric’, ‘TV’, ‘NTP’, ‘Admin’.
•
NTP : Clock is synchronized using Network Time Protocol. It's only enabled when network cable is connected.
•
Admin : It's automatically set to Admin when clock is updated by commercial protocols like TVLink-HCEC, TVLink-Interactive, or HCAP API.
•
Off : Clock is synchronized using any available clock source.
•
Pro: Centric : Clock is synchronized using Pro:Centric server. (Depending on model)
•
TV : Clock is synchronized using particular TV programme.
