LG TD-H802SJW, Руководство пользователя

Страница: 15 / 36

15
EN
Condensed Water Drain-out
Normally, condensed water is pumped up to the
water container where water is collected until
manually emptied. Water can also be drained
out directly to a mains drain, especially when
the dryer is stacked on top of a washing
machine. With a connecting kit for the mains
drain hose, simply change the water path and
re-route to the drainage facility as below:
1
Separate the anti-backflow lid(

) and the
water container hose(  ) from the
connecting kit.
2
Attach the anti-backflow lid(

) to the head
of the connecting kit and then connect the
drain hose(

) to the opposite side of the
connecting kit.
CAUTION
• If the hose is installed in a way that leaves it
bent or pinched, drainage may not function
properly.
Leveling the appliance
Leveling the appliance prevents unnecessary
noise and vibration. Place the appliance on a
solid, level floor.
If the appliance is not properly level, adjust the
front leveling feet as necessary.
Turn them clockwise to raise and counter-
clockwise to lower until the appliance no longer
wobbles, both front-to-back and side-to-side and
corner-to-corner.
Adjustable Feet
Adjustable Feet Adjustable Feet
Diagonal Check
• When pushing down the edges of the top
plate diagonally, the appliance should not
move up and down at all (Check both
directions). If the appliance rocks when
pushing the top plate diagonally, adjust the
feet again.
OPERATION
EN
Using the Appliance
Before the first cycle, set the appliance to dry
for five minutes to warm up the drum. Open the
door between loads the first few times you use
the appliance to allow any odours from the
interior of the appliance to disperse.
1
Ensure the lint filter and water container are
clean.
• The lint filter is inside the door rim. It
needs to be cleaned before each drying
cycle.
• Open the door and ensure the lint filter is
clean. If it is not, please clean the lint
filter.
• Also check if the water container needs to
be emptied for optimum drying results.
WARNING
• Do not drink the condensed water.
NOTE
• In some instances, LED window may display
(Empty water symbol) and the appliance
may stop because the water container is full.
2
Place laundry into the drum after sorting.
• The clothes should be sorted by fabric
type and dryness level and all the strings
and belts of clothes should be well tied
and fixed before being put into the drum.
Push the laundry to the back to keep it
away from the door seal. Otherwise, the
door seal and clothes may be damaged.
Close the door.
CAUTION
• Be careful not to trap laundry between the
door and rubber seal.
3
Turn the power on.
•
Press the Power button. The indicator
icon above the button will become
illuminated, indicating that the appliance is
all set to run.
4
Select the drying programme you want.
• You can choose a programme by turning
the programme selector knob until the
required programme is indicated.
• If you press the Start/Pause button
without choosing a programme, the
appliance will proceed with the Cotton
programme. Please refer to the
programme table for the detailed
information.
5
Press the Start/Pause button.
6
After the cycle has finished, open the door
and remove the laundry.
7
Turn off the appliance.
• Press the Power button.