13
EN
Connecting the Water Inlet
Hose
Before connecting the water inlet hose to the water
tap, check the hose fitting type and then choose
the correct instruction.
Note for Connection
•
Water supply pressure must be between
30
kPa
and
800 kPa
(0.3 - 8.0 kgf / cm²). If the
water supply pressure is more than
800 kPa
, a
decompression device should be installed.
•
Do not overtighten the water inlet hose to the
valve.
•
Periodically check the condition of the hose
and replace the hose if necessary.
Checking the Rubber Seal
Two rubber seals a are supplied with the water
inlet hoses. They are used to prevent water leaks.
Make sure the connection to taps should be
sufficiently tight.
Connecting the Hose to the Water
Tap
Connecting Screw-Type Hose to Tap with
Thread
Screw the hose connector onto the water supply
tap.
NOTE
•
After connecting the water inlet hose to the
water tap, turn on the water tap to flush out
foreign substances (dirt, sand, sawdust, and
etc.) in the water lines. Let the water drain into
a bucket, and check the water temperature.
