B) Connecting to an Apple Macintosh II, Centris and Quadra
Figure 4 shows the connection to an Apple Macintosh, using a sepa-
rately purchased adapter.
1. Power OFF both the monitor and the PC.
2. Connect the 15pin VGA connector of the supplied signal cable to
the matching input on the back of the monitor. Tighten the thumb-
screws to secure the connection.
3. Locate the appropriate MAC to VGA adapter block at your local
computer store. This adapter changes the high density 3 row 15
pin VGA connector to the correct 15 pin 2 row connection to mate
with your MAC. Attach the other end of the signal cable to the side
of the adapter block with 3 rows.
4. Connect the attached adapter block/signal cable to the video out-
put on your MAC.
5. Power ON the PC, then the monitor.
6. If you see the "SELF DIAGNOSTICS" message, check the signal
cable and connectors.
7. After using the system, power OFF the monitor, then the PC.
Figure 4.
7
Power Cord
Signal Cable
D-15P
ADAPTER 15P
Computer
Apple
Macintosh
R
G
B
H+V
V
(Rear of Monitor)
Signal Cable
