Setting the VCR output channel
10
Your TV set receives the video recorder signal like another TV station. So you have to
select a programme number for the video recorder.
Take care to select this programme number, whenever you control the video recorder,
or watch a recording. Only if you have selected this programme number, which we
call video programme number, you will see the picture from the video recorder on the
screen.
If you connect a monitor or a TV set equipped with audio and video terminals, this
adjustment will not necessary. Consult the operating instructions of your TV set.
Connect the video recorder as described in the section on Connections (see on
previous page).
Setting the output channel of the VCR
SETTING THE VIDEO CHANNEL WITH
PLAYBACK
The output channel of the video recorder is set at UHF channel 36.
1
Turn on the TV set and the video recorder.
2
Play any video cassette tape on your video recorder.
3
Select the correct channel (36) on your TV set.
And then you will see the picture being played in video recorder.
(
Note -
You will need to look at the instruction manual for your TV set if you do
not know how to do this.)
SETTING THE VIDEO CHANNEL WITH
OSD (ON SCREEN DISPLAY)
1
Turn on the TV set and the video recorder.
2
Repeat above No. 3. And then you will see a blue background picture on the TV
screen.
3
Store this channel in an unused programme number on your TV set.
Changing the transmitter channel
If the channel 36 is already occupied at your TV set, or if the picture is distorted, you
can change the transmitter channel of the video recorder.
1
Select an unoccupied channel between 22 and 68 on your TV set.
2
During power off mode (only clock display) press the PROG. “
▼
” or “
▲
” buttons
on the VCR for more than 4 seconds.
Then, “RF36” will be displayed on the VCR’s display.
3
Press the PROG. “
▼
” or “
▲
” buttons on the VCR to select another video channel
e.g. between channels 22 and 68.
You can also set it to “OFF” if there is any interference when your TV is connected
to the VCR with a SCART lead.
4
Press the “ ” button when you have finished.
1
2
3
