14
PROGRAMMING MODE
PROGRAMMING MODE
1. Programming mode
You can check machine information or change setting on Program setup or Diagnostic test.
There are two methods that you can enter programming mode.
■
How to enter “Programming mode”
You can enter programming mode only for Idle state
and pause state.
- Card Type
1) Insert service card.
2) Display will show
- Coin Type
1) Dissemble upper coin box key.
2) Take out the coin drop from the coin box.
3) Turn on/off the toggle switch at the back of the coin
box.
4) Display will show “
”.
- OPL Type
1) Push the High Temp. and Low Temp. button at the
same time.
2) Push the Med Temp. button 3 times.
3) Push the Srart button.
4) Display will show “
”
■
How to use button
You can change Dryer vend price, cycle time and Cycle
parameters, etc.
Press button
Description
High Temp.
Move to upper level
Med Temp.
Move to the mode in the
same level (+)
Low Temp.
Move to the modes in the
same level (-)
No Heat
-
Start
Enter the selected mode
• If you turn on the power without connecting the meter case for the first time, the machine will display
.
• When the machine comes from the factory, it is set in the coin type. You can change Card/Coin type by button.
(For more information refer to SETUP mode’s
.)
• The machine will display “PUSH” for OPL type
• Do not enter the “Vend type set up” mode if the machine is a coin type. You cannot restore it back to Coin type
without a special card reader and a service card after it has been changed to Card type in the set up mode.
NOTE
Coin Box Key
Coin Vault
COIN TYPE
Insert debit card
CARD TYPE
OPL TYPE
