LG OTW420B, Инструкция по установке

Страница: 7 / 102

5
ENGLISH
2
How to attach to masonry walls
Please follow the below direction.
-
Check the material of the wall and the thickness of the finishing.
-
Use the anchors for wall material of concrete, light concrete, strong natural stone, soft natural stone masonry brick and hallow
block that do not crack.
-
Do not mount the device on the walls made from plasterboard or medium density fiberboard (MDF). In this case, the anchor and screws must
be inserted into the concrete behind the finish surface. If there is no concrete on the other side, then you must first install a separate hanger
to securely install the anchors and screws.
-
When installing the product on wall material not designated, install the product so that each location can withstand the pull out load
of 70 kgf (686 N) and shear load of 100 kgf (980 N) or above.
a
b
d e
Wall mounting screw
c
Wall mounting anchor
-
Use the Ø 8 mm drill bit for concrete and hammer (Impact) drill.
a. Use a drill bit Ø 8 mm to drill a hole for the anchor location within a depth of 80 mm to 100 mm.
b. Clean the drilled hole.
c. Insert the sealed wall mounting anchor to the hole. (When inserting the anchor, use a hammer.)
d. Set the wall mount on the wall by aligning to the location of the hole. and, set the angle adjusting part to face upward.
e. Align the wall mounting screw to the hole and tighten it. Then, fasten the screws at torque of 45 kgf/cm to 60 kgf/cm.
Work procedure
1. Check to see if the display has screws installed into the mounting holes. If so, remove those.
2. Assemble the guide spacer and the guide spacer screw in order as shown in the picture.
-
Place the TV on a table with the screen facing down. Make sure that you place it on a flat surface covered with a soft cloth or
cushion to protect it from scratches.
-
Secure the guide spacers to the TV with the screws. Assemble the guide spacer to the set by tightening the screw. Tighten the
screw until the set, guide spacer and the screw are fully pressing against one another.
-
Use the + driver (manual or motorized) when tightening the screw.