11
ENGLISH
A
2. Mount set 5, then remove the module-protecting Cover on sets 8 and 5.
Insert 4 Guide pins as shown in the fi gure below.
3. Slowly push down set 5 and insert the guide pins into set 5 as shown below.
* This is a bracket with gas spring, so sets can be adjusted vertically with a small force.
Remove the module-protecting Cover.
(The protective Cover is attached on all four sides; only re-
move fi rst the Cover on the sides where the sets meet.)
CAUTION
when set 5 is mounted the sets may collide and cause damage.
Avoid severe impact to the set when adjusting the gap (seam). Otherwise, this can cause damage to the
module glass.
5
8
5
8
<Fine-tuning the gap between the sets>
Rotate the guide pins to fi ne-tune the
gap between the sets.
Support set 5 with the guide pins
to avoid it going down.
