4
Antenna Connections
Connecting an Outdoor Antenna
For the best reception, we recommend you use an
outdoor antenna.
Severely weathered antennas and antenna cables
can reduce the signal quality. Before connecting it,
necessarily inspect them. Any service center can
explain the various outdoor antennas available to
you.
Connecting a CATV Cable
If you subscribe to a CATV system, change the
antenna connection as described below.
1. Remove the 300 to 75 ohm adapter or the
cable from the set if attached.
2. Connect the CATV cable (75 ohm coaxial
cable) to the antenna jack.
CH.
CH.
Move
+
+
Next
+
{
+
Exit
}
Language
{
Input
{
Key
+
lock
{
Caption
+
{
Auto
+
demo
{
On screen menus
The dialogue between you and your set takes place
on screen with an operator menu .The buttons
required for the operating steps are also displayed.
Menu selection
1.Press the MENU button and then
D
/
E
button to
display each menu.
2.Press the
G
button and then
D
/
E
button to
select a menu item.
3.Press the
G
button to display the sub menu or
the pull-down menu.
4.Change the setting of an item in the sub or pull-
down menu with
F
/
G
or
D
/
E
.You can move to
the higher level menu with ENTER or
F
button and to move to the lower level menu
press the
G
button.
TV programme
CH.
CH.
Move
+
+
Next
+
{
++
Exit
}
Auto
+
prog.
{
Manual
{
Favorite
++
{
CH.
CH.
Move
+
+
Next
+
{
++
Exit
}
Clock
{
Off
_
timer
{
On
+_
timer
{
Auto
+_
off
+
{
CH.
CH.
Move
+
+
Next
+
{
++
Exit
}
APC
+
+
{
Contrast
{
Brightness
+
{
Color
++++++
+
{
Sharpness
+
{
Tint
++++++
+
{
Basic TV operation
Before operating your TV, make sure the following
instructions have been completed.
• Your TV has been connected to an antenna or a
cable system.
• Your TV has been plugged in a power outlet.
• In this manual, the OSD (On Screen Display)
may be different from your TV’s because it is just
an example to help you with the TV operation.
Turning on/off the TV
Press the POWER (or ON/OFF) button on the set.
At this time, the set switches to standby mode and
the standby indicator lights up in red.
To switch the TV on from standby mode, press the
< CH >button on the set or POWER, TV/VIDEO,
CH
D
/
E
or number button on the remote control.
A channel number will be displayed on the screen.
The on-screen display will disappear after a few
seconds.
Press the POWER button on the remote control. It
reverts to standby mode.To switch the TV off,
press the POWER button on the set.
