14 Room Air Conditioner
Suggested Tool Requirements
SCREW, -), RULER, KNIFE, HAMMER, PENCIL, LEVEL
Preparation of Chassis
1. Remove the screws which fasten the cabinet at
both sides and at the back.
2. Slide the unit out from the cabinet by gripping the
base pan handle and pulling forward while
bracing the cabinet.
3. Remove EPS Material.
4. Cut the window sash seal to the proper length. Peel
off the backing and attach the foam-pe
to the
underside of the window sash.
5. Remove the backing from the top upper guide
Foam PE
and attach it to the bottom of the upper
guide
.
6. Attach the upper guide onto the top of the cabinet
with 3 type A screws.
7. Insert the frame guides
into the bottom of the
cabinet.
8. Insert the Frame Curtain
into the upper guide
and frame guides
.
9. Fasten the curtains to the unit with 4 Type A screws
at the both sides.
Cabinet Installation
1. Open the window. Mark a line on center of the win-
dow stool(or desired air conditioner location).
Carefully place the cabinet on the window stool and
align the center mark on the bottom front with the
center line marked in the window stool.
2. Pull the bottom window sash down behind the
upper guide until it meets.
Do not pull the window sash down so
tightly that the movement of Frame
Curtain is restricted.
NOTICE
EPS Material
9
10
11
10
5
5
5
12
12
(Type A)
(Type A)
Upper Guide
Front Angle
Window stool
Upper guide
Window Sash
Cabinet
Frame Curtain
10
1
Shipping screws
Figure 2
Figure 3
Installation
