ENGLISH
11
INSTALLATION
Window Requirements
●
This unit is designed for installation in standard
double hung windows with actual opening
widths from 22" to 36".
The top and bottom window sashes must open
13" from the bottom of the upper sash to the
inside sill.
22" to 36"
13" min
Preparation of Chassis
1
Insert the guide panels into the upper and
bottom guide.
Fasten the curtains to the unit with 4 type A
screws on each side.
Left Guide
Panel
Right Guide
Panel
Upper Guide
Bottom Guide
Use a long screwdriver and installing
the screws will be easier.
NOTE
●
Indoors
Inner Sill
Outer Sill
Storm
Window Frame
Wood Strip Mounted
on Top of Inner Sill
¾"
Clearance
Wood Strip for
L bracket
L Bracket
Outdoors
Foam-PE
(Adhesive backed)
2
Cut the window sash seals to the proper
length. Peel off the backing and attach the
Foam-PE(Adhesive backed) to the
underside of the window sash and bottom
of window frame.
NOTE
●
This prodcut is a WINDOW AIR CONDITIONER.
As such, a standard single-hung or double-hung
window is required for proper installation.
No-window installations, including using sleeves,
holes in walls, and other installations are not
recommended.
1
If a storm window presents interference,
fasten a 2” wide wood strip to the inner
window sill across the full width of the sill.
The wood strip should be thick enough to
raise the height of the window sill so that
the unit can be installed without interference
by the storm window frame.
2
(See drawing.) The top of the wood strip on
the inside sill should be approximately ¾”
higher than the storm window frame or wood
strip on the outside sill to help condensation
to drain properly to the outside.
3
If necessary, install a second wood strip
(same thickness as first strip) in the center
of sill flush against the back off the inner sill.
This will raise the L bracket as shown in
the drawing.
Clearance
Proper clearance enhances the cooling efficiency
of the product.
