LGE CDMA Fixed Wireless Terminal
LST-260
26
Changing Outgoing LOCK Code
1.
Press “#” + “#” + “6” + continuously to enter Outgoing Call Lock programming mode
2.
Press “#” and “LOCK code (4 digits)”
3.
Press “#” and “3” to change LOCK code.
4.
Press “#” and “new LOCK code (4 digits)”.
5.
Press “#” and re-enter “new LOCK code (4 digits)”.
6.
Press “*” to save.
Note :
If emergency call has been enabled, then emergency call numbers stored can be made even
when Outgoing Call Lock has been activated on the terminal.
5.7 G3 FAX / DATA
Mode Setting
To activate a Data Fax call by G3 FAX connected to your LST-260 terminal from the other
devices (Land or Mobile Data Fax), your service provider should support wireless data FAX. And
the LST-260 mode should be changed to G3 FAX mode to change data path from RS-232C to
G3 FAX machine. Because the terminal doesn’t recognize the call is for FAX or voice before
being response. Following is the procedure to change data path and default data path is RS-
232C data path.
Once G3 Fax mode is set, if AC power is gone and turned on again, the saved G3 Fax mode
value is restored
.
Enable or Disable G3 FAX mode (Only LST-260F)
1.
Press “#” + “#” + “7” continuously to enter G3 FAX/DATA programming mode.
2.
Press “#” and Enable (“1”) or Disable (“2”) code.
Enable means that Data call path is changed to G3 FAX.
Disable means that Data call path is changed to RS-232C. (Default mode)
3.
Press “*” to save.
Enable or Disable DATA mode
1. Press “#” + “#” + “7” continuously to enter G3 FAX/DATA programming mode
2. Press “#” and Enable (“3”) or Disable (“4”) code.
Enable means that Data mode is changed to USB mode.
Disable means that Data mode is changed to RS-232C mode. (Default mode)
3. Press “*” to save.
