LGE CDMA Fixed Wireless Terminal
LST-260
15
z
Please make sure that these components are present and check for evidence of shipping
before you begin the unit installation.
z
If components are missing or damage is found, contact your authorized LG distributor
immediately.
STEP 2. Place the Terminal
z
Place the terminal on the stable flat secure surface area (desk, table, etc.).
Avoid direct exposure to the sun lights and damp area.
z
Read
the
Safety Information
located at the first part of this document before you place the
terminal.
STEP 3. Connect Components
z
Connect the Dipole antenna to the TNC connector located at the topside of the terminal.
(See Figure 1 to locate the TNC connector.)
If you placed the terminal on the flat surface, bend the antenna up side.
z
Connect your phone cord to the RJ-11 port located at the side of the terminal.
z
Connect the battery cable to the DC battery connector at the side of the terminal.
-. Remove the battery compartment cover.
-. Connect battery to the connector.
-. Replace the battery cover.
z
Connect the AC power supply cable to the DC input port located at the side of the terminal.
z
If you use Data Service or PC FAX Service, connect your RS-232C cable cord to the RJ-45
port or USB Cable cord to the USB port located at the side of the terminal.
z
If you use G3 FAX machine, connect your line cord of G3 FAX to the RJ-11 port located at
the side of the terminal. (only LST-260F)
“Refer to connection Diagram with external equipment in Figure 2 ”
STEP 4. Check LED Indicators
z
When you followed the installation instruction STEP 1 to STEP 3, please check the LEDs for
normal operation.
z
When DC power is fed at the first time, LEDs will operate as follows:
After few seconds, Power LED is GREEN, if AC/DC power is applied.
If receiving signal strength is strong enough, then SIGNAL LED is GREEN.
If not, it is ORANGE or RED. And MODE LED is turned off.
