10
Part 4
INSTALL THE RANGE
Replace the access cover on the range back. To
replace the wire cover, insert double projections in the
pockets located below the opening and tighten the
three screws.
ANTI-TIP DEVICE INSTALLATION
1.
Locate the bracket using the template
An Anti-tip bracket is packaged with template.
The instructions include necessary information to
complete the installation.
Read and follow range installation instruction sheet
(template).
2.
Level the range
Level the range by adjusting the leveling legs with a
wrench.
Use a spirit level to check your adjustments. Place
the level diagonally on the oven rack, and check each
direction for level.
First check direction
1
.
After check direction
2
.
If the spirit level doesn’t show
level on the rack, adjust the
leveling legs with a wrench.
FINAL INSTALLATION
• Move range close enough to the opening to plug
into the receptacle.
• Slide range into position insuring that the left back
leg slides under the anti-tip bracket. Range will sit 0”
away from the back wall when properly installed.
• Carefully tip range forward to insure that the anti-tip
bracket engages the range back brace and prevents
tip-over.
• Turn on electrical power. Check range for proper
operation as described in owner’s manual.
If the counter does not bridge the opening at the rear
wall the rear filler kit, that is provided with the slide in
range, will be needed.
NOTE : If the countertop depth is greater than 25”
there will be a gap between the filler kit and the back
wall.
If the countertop depth is less than 24”, the control
panel will not sit flush with the countertop.
(See figure 1 on page 5)
5
6
WARNING
• DO NOT step or sit on oven
door. Install the Anti-Tip
Bracket supplied with the
range.
- The range could be tipped and
injury might result from spilled hot
liquid, food, or the range itself.
- If the range is pulled away from
the wall for cleaning, service, or
any other reason, ensure that
the Anti-Tip Device is properly
reengaged when the range is
pushed back against the wall.
Gloves
Safety Glasses
Tape Measure
Pencil
Rear filler & 2 Screws
(LSE Series only)
Gloves
Safety Glasses
Tape Measure
Pencil
Rear filler & 2 Screws
(LSE Series only)
Optional rear filler
