ENGLISH
17
O P E R AT I N G I N S T R U C T I O N S
USING THE CLOCK AND TIMER
HOW TO SET THE CLOCK
The clock should be set to the correct time of day for the
automatic oven timing functions to work properly. The
time of day cannot be changed during cooking or self-
clean mode.
Press the
CLEAR OFF
pad.
Press the
CLOCK
pad.
Press the
+
or
–
pad to set the time of day.
Press the
START
pad.
The clock will be set, and the display will
reflect the change after a short delay.
Press the
TIMER ON/OFF
pad once to set
the time in minutes and seconds, OR press
the pad twice to set the time in hours and
minutes. TIMER will flash in the display.
Press the
+
or
-
pad until the desired time
appears in the display.
Press the
TIMER ON/OFF
pad to start the
countdown. TIMER will show in the display.
NOTE:
If
TIMER ON/OFF
is not pressed, the
timer will return to the time of day.
When the timer reaches :00, End will show
in the display. The clock will sound with 3
beeps every 15 seconds until the
TIMER
ON/OFF
pad is pressed.
HOW TO SET THE TIMER
The
TIMER ON/OFF
serves as an extra timer in the
kitchen that will beep when the set time has run out. It
does not start or stop cooking or control oven operations.
The
TIMER ON/OFF
feature can be used during any of
the other oven control functions.
NOTE:
1. If you press
TIMER ON/OFF
once, it allows you to set
the time in minutes and seconds.
(For example: if you press 50,
it means 50 seconds.)
2. If you press
TIMER ON/OFF
twice, it allows you to set
the time in hours and minutes.
(For example: if you press 5,
it means 5 minutes.)
HOW TO CHANGE THE HOUR MODE ON
THE CLOCK (12 HR OR 24 HR)
Your control is set to use a 12 hour clock. If you would
prefer to have a 24 hour time clock, follow the steps
below.
Press the
CLOCK
pad for three seconds.
Press the
CLOCK
pad to switch between
the 12 hr clock and the 24 hr clock.
Press the
START
pad to accept the desired
change.
NOTE:
If the remaining time is not in the display, recall
the remaining time by pressing the
TIMER ON/OFF
.
HOW TO CANCEL THE TIMER
Press the
TIMER ON/OFF
pad. The display will return to
the time of day.
POWER OUTAGE
If a flashing time is in the display, you have experienced a
power failure. You will need to reset the clock time.
Press the
CLOCK
pad once to reset. Enter the correct
time of day by pressing the + or - pads.
Press the
START
pad.