15
EN
INSTALLATION (HORIZONTAL)
1 Attaching Foam Weather Seals
Cut the mounting plate insulation to the chassis length and insert it on both
sides of the mounting plate.
(Attaching the foam weather seals to the panel assembly rather than the
window sash and frame makes for easier cleanup when removing the panel
assembly.)
NOTE
•
Take care not to block drain holes in the exterior sill. If necessary, cut slots
in the foam seal to allow any moisture to drain out the window sill drains.
Adhesive short foam weather seal
s
Adhesive short foam
weather seal
s
Mounting plate insulation
Indoor
Interlor
Mounting
plate insulation
Mounting
plate insulation
Indoor
Interlor
2 Inserting Panel Assembly
Insert the panel assembly in the bottom sash channel as in step 2. Use care when installing the
assembly, which will now fit very tightly in the opening.
Close the sash tightly against the top of the panel assembly. For a tighter seal, use “no residue” duct
tape (not included) to seal any gaps around the installed panel assembly.
•
If needed, install the included security bracket with a bracket screws.
Bracket screws
Security
brackets
Base mounting
plate
Extension
panel
3 Sealing Gap between Sashes
Measure and cut the included window gap insulation to fit the window opening. Stuff it between the
window sashes to prevent air and insects from getting into the room.
Tip
: For a tighter seal, use “no residue” duct tape to seal the gap between the sashes.
