background image

Warning: 

Do not install this equipment in a 

confined space such as a bookcase or similar 
unit.

Warning:

 Wiring methods shall be in 

accordance with the National Electric Code, 
ANSI/NFPA 70.

Warning:

 This is a class A product. In a 

domestic environment this product may cause 
radio interference in which case the user may 
be required to take adequate measures.

Warning:

 To reduce a risk of fire or electric 

shock, do not expose this product to rain or 
moisture.

Caution:

 This installation shall be made by a 

qualified service person and shall conform to 
all local codes.

Caution: 

To avoid electrical shock, do not 

open the cabinet. Refer servicing to qualified 
personnel only.

Caution:

 The apparatus shall not be exposed 

to water (dripping or splashing) and no objects 
filled with liquids, such as vases, shall be 
placed on the apparatus.

Note:

Please make sure the product is installed 
appropriate places where secured from flood, 
such as under the eaves, to operate properly. 
This product is certified as IP66 standard. 
However, if there is any flood concerns, it 
is highly recommended to use an outdoor 
Housing. When you install the camera inside 
an outdoor Housing, please use one of the 
following methods:
1.   Remove the front glass of Housing before 

installing the camera. 

2.   To keep the front glass of Housing, 

remove the front cover, and then put the 
camera close to the front glass.

To disconnect power from mains, pull 
out the mains cord plug. When installing 
the product, ensure that the plug is easily 
accessible.

LG Electronics hereby declares 
that this/these product(s) is/are 
in compliance with the essential 
requirements and other relevant 
provisions of Directive 2004/108/
EC and 2011/65/EU. 

Contact office for compliance of this 

product:

LG Electronics Inc. 
EU Representative, Krijgsman 1,1186 DM 
Amstelveen, The Netherlands

Disposal of your old appliance

1.  When this crossed-out 

wheeled bin symbol is 
attached to a product 
it means the product is 
covered by the European 
Directive 2002/96/EC.

2.  All electrical and electronic products 

should be disposed of separately 
from the municipal waste stream 
via designated collection facilities 
appointed by the government or the 
local authorities.

3.  The correct disposal of your old 

appliance will help prevent potential 
negative consequences for the 
environment and human health.

4.  For more detailed information about 

disposal of your old appliance, please 
contact your city office, waste disposal 
service or the shop where you 
purchased the product.

EEE Compliance with Directive.  
(for Turkey only)

Important Safety 

Instructions

1.  Read these instructions. 
2.  Keep these instructions. 
3.  Heed all warnings. 

4.  Follow all instructions. 
5.  Do not use this apparatus near water.
6.  Clean only with dry cloth.
7.  Do not block any ventilation openings. 

Install in accordance with the 
manufacturer’s instructions. 

8.  Do not install near any heat sources such 

as radiators, heat registers, stoves, or other 
apparatus (including amplifiers) that 
produce heat. 

9.  Do not defeat the safety purpose of 

the polarized or grounding-type plug. 
A polarized plug has two blades with 
one wider than the other. A grounding 
type plug has two blades and a third 
grounding prong. The wide blade or the 
third prong are provided for your safety. 
If the provided plug does not fit into 
your outlet, consult an electrician for 
replacement of the obsolete outlet.

10.  Protect the power cord from being 

walked on or pinched particularly at 
plugs, convenience receptacles, and the 
point where they exit from the apparatus.

11.  Only use attachments/accessories 

specified by the manufacturer.

12.  Use only with the cart, stand, tripod, 

bracket, or table specified by the 
manufacturer, or sold with the apparatus. 
When a cart is used, use caution when 
moving the cart/apparatus combination 
to avoid injury from tip-over.

13.  Unplug this apparatus during lightning 

storms or when unused for long periods 
of time.

14.  Refer all servicing to qualified service 

personnel. Servicing is required when 

the apparatus has been damaged in any 

way, such as power-supply cord or plug 

is damaged, liquid has been spilled or 

objects have fallen into the apparatus, the 

apparatus has been exposed to rain or 

moisture, does not operate normally, or 

has been dropped.

Handling of the unit

Be careful not to spill water or other liquids on 
the unit. Be cautious not to get combustible or 
metallic material inside the body. If used with 
foreign matter inside, the camera is liable to 
fail or to get cause of fire or electric shock.
• 

Remove dust or dirt on the surface of the 
lens with a blower.

• 

Use a dry soft cloth to clean the body. If it 
is very dirty, use a cloth dampened with a 
small quantity of neutral detergent then 
wipe dry.

• 

Avoid the use of volatile solvents such 
as thinners, alcohol, benzene and 
insecticides. 
They may damage the surface finish and/
or impair the operation of the camera.

Operating and storage 

location

Avoid viewing a very bright object (such as 
light fittings) during an extended period. Avoid 
operating or storing the unit in the following 
locations.
• 

Extremely hot or cold places (operating 
temperature -10 °C to 50 °C, however, we 
recommend that the unit be used within 
a temperature range of 0 °C to 45 °C)

• 

Damp or dust place

• 

Places exposed to rain

• 

Places subject to strong vibration

• 

Close to generators of powerful 
electromagnetic radiation such as radio 
or TV transmitters.

CAUTION

RISK OF ELECTRIC SHOCK  

DO NOT OPEN

CAUTION: 

TO REDUCE THE RISK OF ELECTRIC SHOCK

DO NOT REMOVE COVER (OR BACK)

NO USER-SERVICEABLE PARTS INSIDE

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

This lightning flash with arrowhead symbol within an equilateral triangle is 
intended to alert the user to the presence of uninsulated dangerous voltage 
within the product’s enclosure that may be of sufficient magnitude to 
constitute a risk of electric shock to persons. 

The exclamation point within an equilateral triangle is intended to alert the 
user to the presence of important operating and maintenance (servicing) 
instructions in the literature accompanying the product.

WARNING:

 This product contains chemicals known to the State of California to cause cancer and 

birth defects or other reproductive harm. 

Wash hands after handling.

FCC WARNING: 

This equipment may generate or use radio frequency energy. Changes or 

modifications to this equipment may cause harmful interference unless the modifications are 

expressly approved in the instruction manual. The user could lose the authority to operate this 

equipment if an unauthorized change or modification is made.

REGULATORY INFORMATION: FCC Part 15

This equipment has been tested and found to comply with the limits for a Class A digital device, 

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection 

against harmful interference when the equipment is operated in a commercial environment. 

This equipment generates, uses, and can radiate radio frequency energy and, if not installed 

and used in accordance with the instruction manual, may cause harmful interference to radio 

communications. 

Operation of this equipment in a residential area is likely to cause harmful interference in which 

case the user will be required to correct the interference at his own expense.
• 

A suitable conduit entries, knock-outs or glands shall be provided in the cable entries of this 

product in the end user.

• 

Caution: Danger of explosion if battery is incorrectly replaced. Replaced only with the same or 

equivalent type recommended by the manufacturer. Dispose of used batteries according to 

the manufacturer’s instructions.

• 

Holes in metal, through which insulated wires pass, shall have smooth well rounded surfaces 
or shall be provided with brushings.

This Class A digital apparatus complies with Canadian ICES-003. 
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.

AB28

MODEL

LNU5100R series

Please read this manual carefully before operating  

your set and retain it for future reference.

OWNER'S MANUAL

High Definition Network 

Camera

Item

LNU5100R series

Image Device

6.08 mm (1/3 type) Progressive Scan CMOS  
(1.3 Mega Pixels)

Lens Type

2.8 mm to 10 mm F1.2

Day/Night

ICR

Minimum 
Illumination

Color

0.3 lx (F1.2, Gain : High)

B/W

0 lx (LED On)

IR Distance

30 m

WDR

Support

Image Enhancement 

Backlight Compensation, 2D+3D-DNR, Exposure 
Control, Sens Up Control, AGC, White Balance, 
Privacy Masking, EIS, Sharpness, Digital Zoom, 
Scene mode

Resolution (Maximum)

Up to 1 280 x 1 024

Output 

RJ-45 (Network), RCA (Installation)

Frame Rate (Maximum)

30 fps @ 1280 x 1024, 30 fps @ 720p

Compression 

H.264_HIGH, H.264, MJPEG

Multi-Streaming

Dynamic Profile (Up to 7)

Audio In/Out 

1/1

Audio Compression

G.711, G.726

2-way Audio 

Support

SD Slot

microSD

EVENT

Alarm In/Out

1/1

Motion detection

Support

Event Notification

Relay Out, Email, FTP

Pre Event Buffering

Support

VA

Intelligent Motion 
Detection

Support

Streaming 
Metadata

Support

Trip Zone

Support

Object Counting

Support

Integrated Client 

LVi510

Remote S/W

LVi510, Mobile application (iPhone, Android, iPad)

Connections 

Up to 10

Protection

IP66, Vandal proof

Security 

Password Protection, HTTPS(SSL, TLS)

Ethernet

10/100 Ethernet

Protocol

IPv4 and IPv6

TCP/IP, UDP, HTTP, HTTPS, RTP, RTSP, DHCP, ICMP

IPv4

FTP, SMTP, NTP, ARP, SNMP v1/v2c/v3, DDNS(LG)

Open Protocol

ONVIF 2.2 Profile S,PSIA 1.1

Operation Temperature/Humidity

-10 ºC to 50 ºC / 0 % RH to 80 % RH

Power Source

PoE (IEEE 802.3af ), DC 12 V (±20 %),  
AC 24 V ( ±10% )

Power Consumption

9.9 W

Input current

AC 24 V 

Maximum 590 mA

DC 12 V 

Maximum 690 mA

PoE

Maximum 190 mA

Dimension (W x H x D)

84 mm x 83.5 mm x 339 mm

Weight 

1.4 kg (with Sunshield 1.57 kg) 

Specification

b c  d 

f  g  h

i

j

k l

m

Lens Cover

b

 

Angle adjuster

 

Adjust the camera angle.

c

 

Tilt adjuster

 

Adjust the tilt position.

d

 

Power input terminal

 

Connects to DC 12 V or AC 24 V power supply using proper cables. This camera must 
always be operated DC 12 V or AC 24 V. Certified/Listed Adaptor which comply with LPS.

e

 

AUDIO IN / OUT (Line Level Input/ Output)

ALARM IN&OUT / ALARM IN&OUT RETURN

 

Provides physical interface for sensor and Alarm/Relay.

g

 

ETHERNET/PoE Port

 

Connects to a PC or a network via a hub with a 10 BASE-T/100 BASE-TX cable attached 
RJ-45 connector.

 NOTE:

 

Power over Ethernet (PoE) is a technology that integrates power into a standard LAN 
infrastructure. It enables power to be provided to the network device, such as a network 
camera, using the same cable as that used for network connection. It eliminates the need 
for power outlets at the device locations and enables easier application of uninterruptible 
power supplies (LPS).

h

 

Pan adjuster

 

Adjust the pan position.

i

 

IR Sensor

j

 

IR LED

k

 

Video Out connector

 

Use this jack for checking the picture with portable monitor when install the camera.

l

 

micro SD card slot

 

Insert the micro SD card.

m

 

RESET button

 

Push the button more than 3 seconds, this would restore the factory default network 
related settings.

Part Names and Functions

Отзывы: