- 25 -
- 24 -
1. This appliance must be supplied with correct rating voltage and hertz as shown on instruction manual,
and connected to an individual, properly grounded branch circuit, protected by minimum 15 amp circuit
breaker or time delay fuse.
Wiring must be 2 wires with ground.
2. The power point must be in a accessible location adjacent to and not behind the dishwasher and within
1.2 meters of the dishwasher side. A correctly rated, wired and earthed extension cord may be used if
necessary.
(See Fig. A)
3. The power point must be correctly earthed, if in doubt, have it checked by a qualified Electrician. No
other appliance shall be connected to the same plug outlet by a double adapter or similar plug.
1. Lay the dishwasher on its back.
2. Adjust the legs to the needed height of cabinet as shown at below.
Step 2 : PREPARE ELECTRICAL WIRING
Step 3 : PREPARE DISHWASHER FOR INSTALLATION
CAUTION
For personal safety, remove house fuse or open circuit breaker before installation.
Do not use an extension cord or adapter plug with this appliance.
Electrical and grounding connections must comply with the national electrical code/provincial and
municipal code and/or other local codes.
9. INSTALLATION INSTRUCTION
1. This dishwasher is designed to fit to the size shown as below.
2. Select a location as close to sink as possible for easy connections to water and drain lines.
3. The dishwasher should not be installed more than 3 meters from sink for proper drainage.
4. If dishwasher is to be installed in corner, minimum 5 cm of space is required between the washer and an
adjacent cabinet or a wall.
n
Ensure the floor under the dishwasher is at the same level as the rest of the room to allow for any
service requirements.
Step1: Prepare Cupboard opening
If bare chipboard is adjacent to or above
the dishwasher, it should be sealed with
a waterproofing paint or sealant to prevent
swelling due to steam.
Cut out for hoses and electrical
cables on either side.
( approx.. 100 X 75 )
Cupboard Opening Dimension
( mm )
