• If the door is slanted to the right as shown in
figure C, repeat the procedure shown as below
until the door is operated normally.
1) Unscrew(counter-clockwise) the left leg of
back side to raise that corner.
2) Check the door function after each adjustment.
• Once adjusted correctly, there should be no
friction noises, or resistance when opening the
door.
• If the door is slanted to the left as shown in
figure D, repeat the procedure shown as below
until the door is operated normally.
1) Unscrew(counter-clockwise) the right leg of
back side to raise that corner.
2) Check the door function after each
adjustment.
• Once adjusted correctly, there should be no
friction noises, or resistance when opening the
door.
Fig. C
Fig. D
Case 1. In case the door is slanted to the
right
Case 2. In case the door is slanted to the left
Water tap
Water supply
hose
Valve
INSTALLATION INSTRUCTION
Step 6 :
WATER SUPPLY CONNECTION
Connect the water supply hose to the valve
behind dishwasher and the water tap as shown
in figure.
This dishwasher may be fed with either hot or
cold water. If the water can not be maintained
below 65
℃
, the dishwasher must be
connected to cold water.
When connecting, a teflon sealing tape or
sealing compound should be used to avoid
water leaks. Make sure that the line is not
kinked or sharply bent.
1
2
8
Securely hand tighten supply hose to water
supply.
Plug power supply cord into an earthed
power outlet and switch on.
After installing the product,operate the
dishwasher through one cycle (Quick cycle
is recommended)without loading the
dishes.
When you operate the product the first
time, normal air purging noises may be
heard.
If he noises remain during the wash, turn
the unit off and start a wash cycle once
again.
1
2
Step 7 :
FINAL CHECK AND
ASSEMBLING
After installing the product, Check the ease of
door opening. If it feels tight, is touching the
side of the tub or is difficult to open, It may be
because leveling is required.
Step 8 :
HOW TO LEVEL THE PRODUCT