LG GWA-4166B, Руководство пользователя

Страница: 8 / 13

5
NOTE : Only one jumper should be installed on the jumper connector.
If more than one jumper is installed, the drive may malfunction or be damaged.
Master/Slave setting is determined by jumper installation on the Jumper Connector.
The following table shows the possible jumper settings.
If you use CSEL setting, the MASTER/SLAVE setting will be made automatically, depending
on the hardware configuration. For more details refer to the manual of your computer.
PC Connection
The drive connects to the motherboard of the host computer using an IDE interface cable. You
may connect the Drive as a Slave or Master device, depending on your computer.
To Install as a Master Drive
To install the drive as a Master, the jumper can be left as supplied from the factory.
NOTE : A hard disk is normally installed as the Primary Master on the EIDE (ATAPI) interface. Other EIDE
peripheral devices such as hard drives and DVD Writable/CD-RW Drives are then set differently.
Name Function
Drive set as Master
Drive set as Slave
Drive mode set by CSEL on the host IDE interface
MA
(Master)
SL
(Slave)
CS
(Cable Select)
C
S
S
L
M
A
Primary
connector
Secondary
connector
Master drive (DVD
Writable/CD-RW drive)
(Jumper left as Master)
Motherboard
- OR -
DIGITAL
ANALOG
INTERFACE
POWER
D R
C S M
S L A
G L G
39
1 +5 +12 GND
40
2
AUDIO AUDIO
Master drive
(Booting hard disk)
Primary
connector
Secondary
connector
Master drive (DVD
Writable/CD-RW drive)
(Jumper left as Master)
Slave drive
(Other IDE
drive)
DIGITAL
ANALOG
INTERFACE
POWER
D
R C S M
S L A G L
G
39
1 +5
+12
GND
40
2
AUDIO
AUDIO
DIGITAL
ANALOG
INTERFACE
POWER
D R
C S M
S L A
G L G
39
1 +5 +12 GND
40
2
AUDIO AUDIO
Master drive
(Booting hard disk)