![background image](http://html.mh-extra.com/html/lg/gsa-4166b/gsa-4166b_service-manual_211208016.webp)
16
1. Power Connector
Connects to the power supply (5-and 12-V DC) of
the host computer.
NOTE : Be careful to connect with the proper
polarity. Connecting the wrong way may damage
the system (and is not guaranteed). Usually this
connector can only be attached one-way.
2. IDE Interface Connector
Connect to the IDE (Integrated Device
Electronics) Interface using a 40-pin flat IDE
cable.
NOTE : Do not connect or disconnect the cable
when the power is on, as this could cause a short
circuit and damage the system. Always turn the
power OFF when connecting or disconnecting the
cable.
3. Jumper Connector
This jumper determines whether the drive is
configured as a master or slave. Changing the
master-slave configuration takes effect after
power-on reset.
4. Analog Audio Output Connector
Provides output to a sound card (analog signal).
Generally you need this to play a regular audio
CD.
5. Digital Audio Output Connector
This connector is not supported.
Digital Audio Output
Connector
Jumper Connector
Analog Audio Output Connector
IDE Interface Connector
Power Connector
Rear Panel
Содержание GSA-4166B
Страница 18: ...2 2 Pick up A Release 1 screw C and remove the Pick up Pick up Unit Pick up C Fig 2 2 18 ...
Страница 39: ...43 3 MD Assy For LightScribe Optical Encoder Unit OPU ID Movement Range L 21um ...
Страница 86: ...90 CD Laser Power Setup Result HC_CD Laser Power Setup Result DVD Laser Power Setup Result ...