19
EN
Right Door
<Type1>
If the door is too low, use the spanner type 1 to
rotate the door hinge bolt as shown below.
<Type2>
If the door is too low, lift the right door up and
insert use a pair of long nose pliers to insert
ring sheets until both doors are level.
Fridge door
Fridge door
Freezer door
Freezer door
Height difference
<Type1>
<Type2>
Adjusting the Freezer Door
*Reference
Spanner
Keeper nut
Adjustment hinge pin
1
Loosen the keeper nut by rotating it
counterclockwise using a 19 mm spanner.
To loosen the nut
2
Adjust the difference in the height of the
appliance door by rotating the adjustment
hinge pin clockwise or counterclockwise
with an 8 mm spanner.
Up
Down
3
After adjusting the difference in the height
of the appliance door, fasten the keeper nut
by rotating it clockwise.
To tighten the nut
If it is impossible to adjust the height of the
appliance door through the above method, level
the door according to the following guide.
EN
Adjusting a Tilted Appliance
If the door of the appliance is not level, adjust
the difference in the height of appliance door
using the following method.
NOTE
•
Because the hinge pin may falll out, do not
adjust the height of the appliance door more
than 3 mm.
Adjustment nut
Door Up
Door Down
Height difference
Spanner
Open the door and use the supplied spanner
type 2 to adjust the level of the lower side,
using the nut on the adjustable round foot as
per the below diagram.