LG GMS9331SB, Руководство пользователя

Страница: 13 / 88

13
ENGLISH
INSTALLATION
Notes for Installation
cause vibration and noise causing the product to fall
resulting in injury.
If the product front or rear are not level, put a solid
and push the product to level it horizontally.
Avoid placing the unit near heat sources, direct sunlight
or moisture.
Install accessories such as ice cube box, etc., in their
proper places. They are packed together to prevent
possible damage during shipment.
Connect the power supply cord (or plug) to the outlet.
Don't double up with other appliances on the same
outlet.
Product with handle shall be located at least 55 mm from
the wall on the hinge side to open door by 90°.
The warm air under and behind the product must be
able to escape or power consumption will increase.
Climate Class
The appliance is designed to operate at the limited
range of ambient temperature, depending on climate
zones. Do not use the appliance at the temperature over
the limit. Climate class of your appliance is indicated
on the label with technical description inside the fridge
compartment.
Class Symbol
Ambient
temperature
range ºC
Extended
temperate
SN +10 – +32
Temperate N +16 – +32
Subtropical ST +16 – +38
Tropical T +16 – +43
Extended
temperate
-Tropical
SN-T +10 – +43
Leg Adjustment
To avoid vibration, the unit must be leveled.
If required, adjust the leveling screws to compensate for
The front should be slightly higher than the rear to aid in
door closing.
Leveling screws can be turned easily by tipping the
cabinet slightly.
Turn the leveling screws counterclockwise (
) to
raise the unit, clockwise ( ) to lower it.
To Reverse the Doors
Your product is designed with reversible doors, do that
they may open from either the left of right hand side to
suit your kitchen design.
NOTE
However when you want to reverse the doors
your refrigerators in pairs, you must call to service
center. Revising the doors is not covered by the
warranty.
To Install Refrigerators in Pairs
Your fridge can be installed with freezer in pairs as the
below image.
NOTE
However when you want to install your
refrigerators in pairs, you must call to service
center. Installation condition is not covered by the
warranty.
Electrical Connections (In the UK
Only)
The wires in the mains lead are coloured in accordance
with the following code:
Green and Yellow: Earth
Blue: Neutral
Brown: Live
This appliance must be earthed.
Green and
Yellow (Earth)
Brown (Live)
Blue (Neutral)
Fuse
Cord grip
As the colours of the wires in the mains lead of this
apparatus may not correspond with the coloured
markings identifying the terminals in your plug, proceed
as follows:
The green and yellow wire must be connected to the
terminal in the plug which is marked with the letter E or
by the earth symbol (
) or coloured Green or Green
and Yellow.
The blue wire must be connected to the terminal which
is marked with the letter N or coloured Black.
The brown wire must be connected to the terminal which
is marked with the letter L or coloured Red.
1362 fuse.