LG GM-U600RSC, Руководство пользователя

Страница: 18 / 64

17 INSTALLATION
ENGLISH
7
8
9
a)
b)
c)
10
CONNECT THE TUBING TO THE VALVE
Place the compression nut and ferrule (sleeve) for
the copper tubing onto the end of the tubing and
connect it to the shutoff valve. Make sure the
tubing is fully inserted into the valve. Tighten the
compression nut securely.
FLUSH OUT THE TUBING
Turn the main water supply on and
flush out the tubing until the
water is clear. Shut the water off
at the water valve after about one
quart of water has been flushed
through the tubing.
CONNECT THE TUBING TO THE
REFRIGERATOR
NOTE:
Before making the connection to the
Refrigerator, be sure that the refrigerator power
cord is not plugged into the wall outlet.
Remove the plastic flexible cap from the water
valve.
Place the compression nut and ferrule (sleeve)
onto the end of the tubing as shown.
Insert the end of the copper tubing into the
connection as far as possible. While holding the
tubing, tighten the fitting.
TURN THE WATER ON AT THE SHUTOFF VALVE
Tighten any connections that leak.
PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the
wall. Push the refrigerator back to the wall.
START THE ICEMAKER
Set the icemaker power switch to the ON position.
The icemaker will not begin to operate until it
reaches its operating temperature of 15 °F (–9 °C)
or below. It will then begin operation automatically
if the icemaker power switch is in the ON (I)
position.
Plug in the refrigerator.
Turn the leveling leg to the left to raise that side of
the refrigerator or to the right to lower it. It may
take several turns of the leveling leg to adjust the
tilt of the refrigerator.
Saddle-Type
Shutoff Valve
Packing Nut
Outlet Valve
Compression
Nut
Ferrule (sleeve)
Tubing Clamp
1/4 inch (6,35 mm)
Tubing
1/4 inch (6,35 mm)
Compression Nut
Refrigerator
Connection
Ferrule
(sleeve)
CAUTION
Check to see if leaks occur at the water line
connections.
11
12
1
Leveling
After installing, plug the refrigerator’s power cord into
a 3-prong grounded outlet and push the refrigerator
into the final position.
Your refrigerator has three front leveling legs (one on
the right and one on the left). Adjust the legs to alter
the tilt from front-to-back or side-to-side. If your refrig-
erator seems unsteady, or you want the doors to
close more easily, adjust the refrigerator’s tilt using
the instructions below:
NOTE:
Third leveling screw is used for protection of
hinge lower.
1
Turning On The Power
CAUTION
Connect to a rated power outlet.
Have a certified electrician check the wall outlet
and wiring for proper grounding.
Do not damage or cut off the ground terminal of
the power plug.
Used hose-sets should not be used, only use
the new hose-sets supplied by the manufac-
turer.
Leveling and Door Alignment