LG F2T1TNM0W, Руководство пользователя, Страница: 41 / 96

EN - 37
FAULT POSSIBLE CAUSE TROUBLESHOOTING
Excessive foam is
formed in the detergent
drawer.
Excessive amount of
detergent used.
Press the Start/Pause button. To stop the
foam, dilute one tablespoon of softener
into 1/2 litre of water and pour into the
detergent drawer. Press the Start/Pause
button after 5-10 mins.
Wrong detergent used.
Only use detergents produced for
automatic Washing Machines.
Unsatisfactory washing
result.
Your washing is too dirty for
the programme selected.
Use the information in the programme
tables to select the most appropriate
programme.
Amount of detergent used
insufficient.
Use the amount of detergent as instructed
on the packaging.
There is too much laundry in
your machine.
Check that the maximum capacity for
the selected programme has not been
exceeded.
Unsatisfactory washing
result.
Hard water.
Increase the amount of detergent following
the manufacturer’s instructions.
Your laundry is too tightly
packed together in the drum.
Check that your laundry is spread out.
As soon as the machine
is loaded with water,
water discharges.
The end of water drain hose is
too low for the machine.
Check that the drain hose is at a suitable
height. (**) .
No water appears in the
drum during washing.
No fault. Water is in the
unseen part of the drum.
. . . . . . . . . . . . . . . . . . . . .
Laundry has
detergent residue.
Non-dissolving particles of
some detergents may appear
on your laundry as white
spots.
Perform an extra rinse, or clean your
laundry with a brush after it dries.
Grey spots appear on
the laundry.
There is untreated oil, cream
or ointment on your laundry.
Use the amount of detergent as instructed
on the packaging in the next wash.
The spin cycle does not
take place or takes place
later than expected.
No fault. The Unbalanced
load control system has been
activated.
The Unbalanced load control system will
try to spread your laundry. The spinning
cycle will begin once your laundry is
spread. Load the drum evenly for the next
wash.
(*) See the chapter regarding maintenance and cleaning of your
machine.
(**) See the chapter regarding installation of your machine.