18
PROBLEM
• This is normal.
• Steam is released at different stages of the cycle
for each option.
Cannot see steam
vapor at the
beginning of cycle.
• MORE TIME button
pressed.
• Pressing the MORE TIME button several times will
set the cycle for a large load such as a comforter.
The display shows
BULKY LOAD.
• STEAM FRESH™ did
not remove odor
completely.
• Fabrics containing strong odors should be washed in
a normal cycle.
Odors remain in
clothing after
STEAM FRESH™.
POSSIBLE CAUSES
SOLUTIONS
DISPLAY
Thermistor of blower
housing
• Thermistor open or shorted
tE1
Checking Part
Cause
• tE1 error is displayed in the drying
cycle or test mode.
• Replace the steam generator.
Door SW
• Door SW is abnormal. (Only
TEST MODE )
• dE error is only displayed in the
test mode.
tE2
dE
Wire Connection
(Black-White-Red)
Wire Connection is wrong.
Wire Connection is loose.
See the 7-9 page.
Guidance of the wire connection.
For only electric dryer.
*PS : Power Supply
PS
Thermistor of steam
generator
• Steam generator thermistor
open or shorted.
• tE4 error is only displayed in the
test mode.
• Replace the steam generator.
tE4
Steam generator
• Sensors do not detect that
steam generator is full within 60
seconds.
If water in the steam feeder is not
enough this error may be isplayed.
Fill the feeder and restart the cycle.
Water supply pump
• When the pump valve is less than
10 in the test mode
• E5 error is only displayed in the
test mode.
• Check the connection between
harness wire and connector.
• Replace the water supply pump.
E5
EE PROM Error
• EE PROM operation is abnormal. • EE error is only displayed in the
test mode.
EE
Add
Water
Remark
8-3. Display Fault/Error Codes for Steam Dryer
The error codes below will be displayed when attempting to start a drying cycle, or after
activating the Diagnostic Test mode.
