10 | InTroduCTIon
Single Zone
Art Cool Gallery Owner
’s Manual
Due to our policy of continuous product innovation, some specifications may change without notification.
unit OPeratiOn
remote Control
installing batteries into remote Control
installing the remote Control Holder
1. Insert AAA batteries (1.5V) before turning on the remote.
2. Remove the battery cover from the back of the unit, by pushing
down the tab at the top of the cover ((1) Figure 2).
3. Lift battery cover off of the unit as shown ((2) Figure 2).
4. Insert the batteries, following the + and - terminal indications
inside the battery compartment. Make sure battery is securely in
place (Figure 3).
5. Reattach the battery cover.
• If the display screen of the remote control starts to fade, replace the
batteries.
• When batteries are removed, the temperature unit will be reset to
Celsius as the default.
Installation of the remote control holder should be out of direct sunlight, in
order to protect the remote control from heat exposure.
1. Choose a safe and easily accessible place to attach the remote
control holder.
2. Using a phillips head screwdriver, insert and fasten the 2 screws
into the holes at the base (Figure 4).
3. Gently “wiggle” the base to make sure that it is firmly attached to
the wall. Tighten the screws further if you feel the wall mount is
still loose.
4. Slide the remote control vertically into the holder (Figure 5).
Figure 2: Remote Control Battery Cover
Figure 3: Battery Placement
Figure 4: Holder Attachment
Figure 5: Insertion of Remote into Holder
Single Zone Art Cool Gallery
