LG Aria LDK 300, Руководство пользователя

Страница: 77 / 87

GDK-162/100/FPII/20W & LDK-24/100/300/300E WOTS
Wireless Terminal (GDC-345H) User Guide
7. TROUBLESHOOTING GUIDE
Problem Reason Solution
LCD is empty.
No power
Check the battery then, press the
[PWR] button.
“ NO CHANNEL ” is displayed
when pressing [ON/OFF]
button.
No free channel
Wait until a free channel is released.
Small Voice Small voice level
While connected to a call,
Press UP ( ) button.
Small Ring Small ring volume level
Adjust Ring volume level;
Refer to ‘ HS Setting ’.
“ UNREGISTERED ” is displayed
on the LCD.
Not subscribed
Subscribe the terminal.
Refer to ‘6.2 Subscription’.
Low battery icon( ) is
flashing on LCD with warning
tone.
Low battery level Recharge the battery.
Power-off right after power-on
Almost fully
discharged battery
Recharge the battery.
No Base Lock State
Wait until Base Locked or move to a
place with good RSSI
1
.
No tone is heard when pressing
a digit.
Tone Volume is off
Adjust Key tone level;
In an idle state
Refer to ‘ HS Setting ’
Unexpected call disconnect or
call failure Bad radio
Environment
Radio environment is changed
unexpectedly even in the same place.
Move to another place with good RSSI
or wait until RSSI is recovered.
Different battery duration from
the battery duration table
Bad charging habit or kept
the battery inadequate
place.
Charge and keep the battery
according to the suggested ways.
Refer to ‘3. Maintenance’.
Subscript can’t be done.
1. There is interference of
other systems with
subscription.
2. A station is too far from
the terminal.
3. Wrong PARK value or
(and) wrong AC code
4. There is no available
wireless channel.
1. Remove other systems.
2. Be sure a batation is close to the
terminal.
3. Be sure PARK value and AC
code are correct.
4. Wait unan available wireless
channel is free. If the subscription
still fails, retry of the power reset.
When pressing TALK button,
Phone icon ( ) is blinking
several times and disappeared.
Subscription Disagreement
Do desubscribe locally in both sides,
the system and the terminal and
subscribe the terminal in the system
again.
When pressing TALK button,
nothing is happened.
Out of Range
1. Be sure the terminal is locked to a
base station.
2. Be sure the system is operating
properly.
1
RSSI : Radio Signal Strength Indication. Always a user can see RSSI icon while the terminal is operating.
７１