MODE
16
OPERATING INSTRUCTIONS
Defrost Mode
1
During defrost operation,
M
will be indi-
cated at display section of indoor.
2
During heating operation, if outside tem-
perature is low and humidity is high, heat-
ing capability will be deteriorated as frost is
generated at outdoor unit, therefore, the
frost will be removed by performing de-
frost operation.
3
When indoor and outdoor unit fans are au-
tomatically stopped and defrost operation
is completed, preheating for heating cycle
will automatically be started.
* Heating operation will be started in a lit-
tle time.
Child Lock Operation Function
1
Press the
and high
simultaneously
for 3 seconds. Or press the
X
button on
remote control.
2
During child lock operation,
-
Whenever you press any button on dis-
play panel, it will immediately display
"CL", which means display panel is
locked.
-
All the button on the indoor unit display
panel will not work.
-
But the button on the remote controller
will be operated.
3
Press the
and high
simultaneously
for 3 seconds again. The unit will respond
with beep. child lock operation will re-
moved
Auto Dry Function
1
Auto dry function can be setted/released
by manipulating indoor unit button or re-
mote control.
2
When pressing the
button after setting
the function, evaporator in indoor unit will
be automatically dried as showing counting
00 to 99 on its display panel .
3
After indicating 99 on the display panel,
the unit will be automatically turned off.
* Auto dry function is released at initial
state as standard.
For Setting Auto Dry Function
If manipulating indoor unit, press the
button and
MODE
button simultaneously for 3
seconds.
If manipulating remote control for Cooling
Only model, press
button.
The indoor unit will respond with beep once
and indicate “SC” on its display panel. Then
Auto dry function will be set.
For Releasing Auto Dry Function
If manipulating indoor unit, press the
button and
button simultaneously for 3
seconds.
If manipulating remote control for Cooling
Only model, press
button.
The indoor unit will respond with beep twice
and Auto dry function will be removed.
MODE
MODE
MODE
Heat Pump
!
NOTE
What is preheating function for heating cycle?
•
During the heating, indoor fan will not be oper-
ated until indoor tubing temperature becomes
more than 22 °C, therefore, this is the function
to block the discharge of cold wind.
•
During the preheating for heating cycle, heat-
ing cannot be performed.
•
During defrost operation, vapor can be gener-
ated at outdoor side, and this is not a failure
because it is the operation to remove frost.
EN
GL
IS
H
