Automatic Drying Rack installation Manual (Entire model)
Standard apartment (Normal slave for seal) installation manual
1. Step :
Secure space for installation
Secure space from the front, rear, side for more than 100mm
Make sure no obstacles such as door, windows, rack or etc.
2. Step :
Secure Electronic line
Warning : Turn off CB, attached connector
For easy After service and avoid electronic shork
Make sure connect right side to avoid unpluged.
If On/off switch is mounted the wall
Cause of customer unconvenince and unstable power supply
Changed composition of power example photo4)
3. Step :
Mark position of anchor
Secure the space and mark 4 position of Anchor
4. Step :
Make hole of Anchor
Make depth 4 positions of Anchor between 30 to 35mm
Warning : Not exceed more than 40mm : danger of broken electric line or water pipe
5. Step :
Stained anchor
Stained 4 anchor example photo6
※ Warning Make sure use more than 5/16" size anchor to avoid drop down
Wedge anchor - make sure put more than 1cm of head of anchor
Strong anchor - Stained with hammer correctly
Do not use screw or other materials to stained, it cause of drop down
6. Step :
Mounted body and connect power supply
Mounted body for example photo8, connect power supply thru hole of body
Wall mounted switch, connect signal line thru hole of body to PCB
Connect power supply for example photo9
When complete connected 'Beep' sound from PCB
To avoid electronic short from moisture
Line shoul be twisted U style and connect
7. Step :
Connect Anchor nut
Tight nus as strong as possible inside of the body
Actuall hanging anchor
nut
Photo5) Mark position
100mm
100mm
2000mm
Photo1) Front
Photo9) Power supply
(Green, Margenta complex is groud)
Photo3) power supply
(Green is earth)
Photo4) Mounted SW
Blue -Drying rack
Photo2) Side
100mm
100mm
700mm
Photo6) Stained anchor(Wedge anchor)
Photo7) Stained anchor(Strong anchor)
그림
8)
본체
걸기
'U'
형태
