8. Step :
Function test and install the cover (★ Attention ★)
Pulled side of wire weather any materials touched it or not
Up and down, limit switch for obstables function test
If LED lights is attached, line connect to PCB and function test
9. Step :
Attached pipe bracket to X-link
Release tie and down the X-link
X-link washer movement is sensor direction
Insert wire head into bracket for example photo11
Insert front of wire head into bracket for example photo12
Insert rear of wire head into bracket for example photo13
Attention : Placed outside first, inside first cause of bend of X-link
Stained plastic materials put from inside see photo14
Photo15) Hang the bracket
10. Step :
Hang the pipe
Placed 2 side pipe into 4 main pipe
※ Easy placed side pipe, place correctly to put out
Parts for main pipe shoul comes out
Pully assembled 4 pipes placed into pipe bracket both side and stained
※ For safety, make the proper position between pipe bracket and pipe
See photo17
11. Sept :
Installation option parts
If hook or multipurpose hook is avaiable, hanging the pipes
If wall mounted switch, placed it correctly
12. Step :
Function TEST
Use remote control for the function test
Welltech co.,ltd
Customer service : +82 2 1600-5470
Warranty service : 1 year after installation
www.momeasy.co.kr Operation hours : 10:00 ~ 18:00
photo12) Attached pipe bracket
Photo11) hang the wire
Photo15) Hang the bracket
photo10) Pipe bracket
Sensor direction
photo13) Pipe bracket
Photo14) Hang the bracket
Photo16) Placed side pipe
Photo17) Insert pipe
