Installation
Connecting to an Apple
Macintosh PC
Connecting the Monitor
Figure 2 shows the connection to an Apple Macintosh, using a
separately purchased adapter.
1.
Power OFF both the monitor and the PC.
2.
Locate the appropriate MAC to VGA adapter block at your local
computer store. This adapter changes the high density 3 row 15 pin
VGA connector to the correct 15 pin 2 row connection to mate with
your MAC. Attach the other end of the signal cable to the side of the
adapter block with 3 rows.
3.
Connect the attached adapter block/signal cable to the video output on
your MAC.
4.
Power ON the PC, then the monitor.
5.
If you see the
NO SIGNAL
message, check the signal cable and
connectors.
6.
After using the system, power OFF the monitor, then the PC.
Figure 2.
M A C 6
M A C 6
Power Cord
Signal Cable
D-15P
Adapter 15P
A5
