Plastic anchors
INSTALLATION GUIDE MAP
10mm(0.39")
INST
ALLA
TION GU
IN
ST
AIIA
TIO
N GU
IDE M
AP
Put an Installation Guide Map
on the desired surface.
Make a hole with diameter of 6mm(0.24")
and depth of 30-35mm(1.18"~1.38") when
piercing a screw point.
Drive the fore plastic anchors into
drilled points.
Hang the hole of product at the upper
screws. (In this time, Remove the map)
(Falling attention)
Check the fixed product with light
power.
Look at suited horizon by horizontal
meter on the horizontal setting line,
and Fix lightly the map by adhesive
tape.
Drill the piercing part for connecting
pipe as diameter 50mm(1.97").
(In case of piercing rear surface)
Refer to No. 5 on this page when making a hole in the wall.
First, Drive the two points of the
upper parts by screws.
(Leave 10mm(0.39") for hanging product)
Drive the lower parts after facing
the hole of product with plastic
anchors, and fix completely the
upper screws.
In case of nothing wrong in the matter,
connect the pipe and the wire.
(Installation manual reference)
Horizontality
INS
TA
LL
AT
IO
N G
UID
E M
AP
Plastic anchors
IN
STA
LL
AT
IO
N G
UID
E M
AP
INST
ALLA
TIO
N GU
IDE M
AP
Hanger hole
(Rear side of
product)
6
Preparing work for installation
Drill a hole in the wall
■
Drill the piping hole with a Ø50mm(1.97”)
hole core drill. Drill the piping hole at either
the right or the left with the hole slightly
slanted to the outdoor side.
5-7mm
(0.2~0.3")
Indoor
WALL
Outdoor
A
A
B
C
D
E
F
G
H
I
J
Sticking the installation guide map and fixing Indoor unit
