LG 36k, Руководство по установке

Страница: 15 / 25

14
INSTALLATION
ENGLISH
Preventing foreign objects from entering
(refer to figure 2)
- Plug the pipe through-holes with putty or
insulation material(procured locally)to stop up
all gaps,as shown in the figure 2.
- Insects or small animals entering the outdoor
unit may cause a short circuit in the electrical
box.
Forming the piping
Form the piping by wrapping the connecting
portion of the indoor unit with insulation mate-
rial and secure it with two kinds of vinyl tape.
- If you want to connect an additional drain
hose, the end of the drain outlet should be
routed above the ground. Secure the drain
hose appropriately.
Gas side piping
(Bigger Dia.)
Liquid side piping
(Smaller Dia.)
Drain hose
Connecting wire
Connection pipe
<Figure 2>
Putty or insulating material
(produced locally)
CAUTION
Insects or small animals entering the
outdoor unit may cause a short circuit in
the electrical box.
!
In cases where the outdoor unit is installed
below the indoor unit perform the following.
1
Tape the piping, drain hose and connecting
cable from down to up.
2
Secure the tapped piping along the exterior
wall using saddle or equivalent.
Trap
Seal a small opening
around the pipings
with gum type sealer.
OU
TD
OO
R
UN
IT
• Trap is required to prevent water from entering
into electrical parts.
Taping
Drain hose
Pipings
Connecting
cable
Power supply
cord
Plastic Plastic
band
band
Plastic
band
Seal a small Seal a small
opening around
opening around
the pipings with
the pipings with
gum type sealer.
gum type sealer.
Seal a small
opening around
the pipings with
gum type sealant.
OUTDOOR OU
TD
OO
R
UNIT UN
IT
OUTDOOR
UNIT
Precautions in bending
1
If it is necessary to bend or stretch the tub-
ing, use the spring which is attached to the
tubing instead of pipe bender.
- Please make a careful notice to make a
smooth line.
- Hold the tubing with your two hands
closely and then bend or stretch it slowly
not to make any crack.
- Remember that the radius (R) should not
exceed 70mm (Refer to Fig. 1)
2
Do not repeat the bending process to pre-
vent the tubing from cracking or crushing.
3
Keep in mind that the bending part should
not be cracked and make the radius (R) as
long as possible (Refer to Fig. 2)
Spring
R70mm
(Fig. 1)
(Fig. 2)
R