LG 32LP2DC-UA, Руководство по обслуживанию

Страница: 13 / 47

- 13 -
3.2.2 Adjustment Method
A) Enter the 100% Vertical Color Bar Pattern (TVBAR_100)
of the 720P Mode supported for entry of component and
select entry selection to Component1 or Component2
and then select image to 'Normal'.
B) After waiting for more than a second after receipt of
signal, enter into 'Ez?Adjust' by pressing the ADJ Key on
the Adjustment R/C. Adjustment is automatically done if
pressing the (+) key after selecting the '1. AD9883A-
Set'.
C) If adjustment is normally completed, 'AD9883£
≠
Set'
message is displayed, and if not normally completed,
'AD9883A Setup Error' message is displayed.
D) If adjustment is completed, exit the adjustment mode by
pressing the ADJ key.
3.3 Color adjustment of main/subsidiary part
Color adjustment of main/subsidiary part is intended to
reduce color difference of the main/subsidiary part in the
PIP/POP/SPLIT Screen.
A) After entering inner signal, enter into the 'Ez?Adjust' by
pressing the ADJ key of the remote control for
adjustment and select the '2.VPX3226' and enter into the
Adjustment Mode by pressing the right key ( ).
B) The screen automatically becomes a TV 6CH SPLIT
Screen if entering into the Adjustment and a window
appears as below.
< Screen Adjustment Command Table. (RS-232) >
C) Firstly adjust '1.Contrast (Main)' so that figure of "US
6CH" character of the left main screen is shown mostly
clearly and vividly (so that saturation is not done) and set
the '2.Contrast(Sub)' to same value. In this case, adjust it
by using the /- key.
D) If adjustment is completed, exit the Adjustment Mode by
pressing the ADJ key.
<Adjustment Pattern : 720P Vertical Color Bar>
VPX3226
1. Contrast(MAIN)
31
2. Contrast(Sub) 31
US 6CH US 6CH