LG 32LH1DC1 - - 32" LCD TV, Инструкция по установке и эксплуатации

Страница: 74 / 84

APPENDIX
74
APPENDIX
CLONING PROCEDURE TROUBLESHOOTING
Warning: Do not use LT2002 while a
LodgeNet PPV card is installed in TV or clone
programmer will be damaged.
Reset Clone After Static Shock
After replacing exhausted batteries, or if the programmer
behaves strangely after a static shock, activate the
internal reset switch and restore normal operation.
After a reset, check the real-time clock setting. It may
be necessary to reset the Clone Programmer clock from
a TV containing the correct time.
*Note: The LT2002 programmer is designed to be used with TVs
con-tain-ing the 221-01006 and later processors. Use with earlier
TV sets may give unpredictable results. Processors used before the
221-01006-04 have a limited screen display capability. They
cannot display entire screens as shown in the quick setup
instructions accompanying the LT2002 clone programmer. Use the
printed menu illustrations on the quick setup sheet supplied with the
Clone as an aid to making your programming choices. (Although the
menus are not all displayed, the clone functions all operate normally.)
IMPORTANT INSTALLER SETUP INFORMATION! PLEASE READ THE FOLLOWING...
8
Only use an appropriate Installer remote to operate clone programmer with 32LH1DC1.
Wrong Installer remote.
Remote does not operate clone.
8
Connect 32LH1DC1 to a reliable Analog channel signal source.
Weak signal.
Clone menu hard to read.
8
Set time on a TV, copy time to Clone Programmer.
Time not available.
No time set.
8
Connect M.P.I. cord.
M.P.I. cord not connected.
8
32LH1DC1 must be powered On for clone to work.
32LH1DC1 not turned on.
8
Install 4 fresh AA high-quality alkaline batteries.
Weak batteries.
LED does not blink