4 Installation
Please always check if the voltage on the sticker of the
electronic box matches with the plug type and your electricity
network before installation. Please contact your dealer
immediately if this is not the case.
6
EN
4.1
Installation of the electronic box
The electronic box should be attached to a wall, with the cables facing
downwards.
1) Remove the design strips on the sides of the box by carefully
pulling them on both sides.
2) Mark the fixing holes from the electronic box at the place
where the box is to be mounted. Drill four corresponding
holes into the wall.
3) Insert the four supplied screws into the fixing holes of the
e-box.
4) Mount the electronic box to the wall with the supplied screws.
5) Carefully place the design strips back at the sides of the box.
Make sure the connectors and wires always point down.
Always install the e-Box in such a way that it is protected
from direct sunlight and rain. Use a separate enclosure if necessary.
